Tudnivaló:
Konnwei KW902 - I added an OBD extension wire with a switch. This solves the possible problems that the KW902 has. 1/drawing power when the car is off. 2/having an insecure password.
I use an EXCEL module (v1.5 OBD2). eBay seller (can find on aliexpress, too).
This module have a bluetooth chip/card manufactured for PC product (it can not freeze over long time sampling like 4 hours). You can see this because the module is transparent.
Achieve 1 cycle every 2 second on Kia Soul EV (read ALL PIDs values every 2 second).
You can speed up this ... but you loose somes values on every fire.
So i prefer have all values and wait the 2 seconds cycle.
Don't work with "fast communication" algorythm of Torque Pro (the module restart every 10 seconds if you activate this).
Probléma:
I have recently been getting reports of strange things happening (I-Key error) when newly bought Konnwei KW-902 adapters are plugged into the Leaf.
I bought one this week and got it today from A mazon and had the same problem.
On opening it up I noticed they have changed the circuit board from the board in the old one I have been using.
The problem is that on at least some they have used the wrong resistor across the CAN bus. The spec is 120 ohms across pins 6 and 14. They are using a 20 ohm resistor which is a near short of the CAN bus. If they are using automated equipment to build their boards then they most likely loaded the wrong reel of resistors. That means there are potentially many many of these out there.
Before plugging in a newly bought Konnwei KW-902 into your L eaf please have the resistance between pins 6 and 14 measured. If it is not 120 ohms return for a replacement until you get one with the correct resistor in it.
Shorting out the CAN bus is very serious. If you experience any strange behavior when using any OBDII adapter immediately stop using it and have the resistance checked. Never drive your L eaf under these conditions.
Adapter komptabilis:
http://www.mykiasoulev.com/forum/viewtopic.php?f=6&t=711&start=20#p6934
fórum:
http://www.mykiasoulev.com/forum/viewtopic.php?f=6&t=711&sid=f50b22c8c97222769da1213a5b3c7b2c
(OBDLink Lx-et is NO-ra mondja)
Az OBDLink MX viszont tuti működik!
Eszköz:
https://www.amazon.com/KW902-ELM327-Bluetooth-Diagnostic-Scanner/dp/B01FJGWPSO/?tag=myelecarfor-20&
OBD sw, fórum:
http://canze.fisch.lu/dongle-test-script/
